Instructions X-BSD Radar

Notice:
This product only reminds you to ride safely, but cannot
guarantee your riding safety. Please ride legally and safely
according to actual traffic conditions.

Thank you for choosing our X-Blind Spot Detection Radar. This device gives you visual warnings when trafic closes up in your Blind Spot from behind.

Accessories

2. Wiring instructions

A. Connect the black power cord to the negative terminal of
the battery and the red power cord to the motorcycle’s ACC
line.

B. When the ACC setting is OFF, there should be no output and the multi-meter should not display anything; when the ACC setting is ON, the multi-meter should display 12V voltage, indicating that the ACC power cord has been located.

C. If you still cannot find the ACC line, please use the red probe to repeatedly change the test wire (keep the black probe connected to the negative terminal unchanged) until you find the ACC power line. If your motorcycle has a USB port, you can use a USB cable for power supply.

3. Installation Diagram

The main body is installed vertically downwards
(with the light on top).

4. Radar warnings
The radar simultaneously monitors vehicles approaching from three directions behind:

Distance (Meters)	Target detected
30M-13M	Any target: The left and right warning orange lights will flash simultaneously twice.
13M-0M	Left-side target: Left-side warning red light illuminated.
13M-0M	Right-side target: Right-side warning red light illuminated.
13M-0M	Rear target: Rear warning light flashes three times.

5. How to use

This product only supports 12-24V to 5V 2A power supply and can be started with the vehicle without manual switching.

Use adhesive tape to install the warning light in the position of the rear view mirror or other conspicuous location.

The left and right alarm lights must be installed on the left and right sides respectively; reverse installation is prohibited.

6. Main parameters

Operating frequency	60GHz
Horizontal signal angle	120°
Operating temperature	-40 to 85 ℃
Warning speed range	7.2 km/h ~ 130 km/h
Warning range	horizontal -3.75m~+3.75m, vertical 0~30m
Distance measurement accuracy	± 0.5M
Reminder Method	The left and right lights flashed, and the rear lights flashed.
Trigger time	Less than 2 seconds
Operating voltage	Input: 12V-24V / USB 5V2A
Waterproof rating	IP67
Applicable models	All motorcycle models

Waste

Electrical and electronic equipment (EEE) contains materials, components and substances that may be dangerous and harmful to human health and to the environment when electrical and electronic waste equipment (WEEE) is not disposed of correctly

Products marked with the “crossed out bin” below are electrical and
electronic equipment. The crossed dustbin symbolizes that electrical and electronic waste equipment must not be disposed of together with unsorted household waste, but must be collected separately as electronic scrap.

warranty

2 years according to the provisions of the Purchase Act.

Support

Tlf. nr.: +45 93943696
E-mail: support@x-mcparts.com